Efflux Time Lab Report

Efflux Time Lab Report. Measure the time required for the leading edge of the meniscus to pass between the two consecutive pairs of the timing marks E to F in seconds Accuracy of 01 seconds is required If this efflux time comes less than 60 sec select a smaller capillary diameter viscometer and repeat the above procedure For BS UTube Modified Reverseflow.

PDF fileThe efflux time can also be converted to kinematic viscosities (centistokes cSt) through the conversion equations Also used in paint a Stormer viscometer uses loadbased rotation in order to determine viscosity The viscosity is reported in.

I'm writing a Lab report on the Efflux time of a fluid in

Time (sec) Q (l/h) Qrot (l/h) H 1 (m) H 2 (m) H 3 (m) H 4 (m) H 5 (m) H 6 (m) 5 REPORT In your laboratory reports must have the followings a) Cover b) A short introduction c) All the necessary calculations using measured data d) Discussion of your results and a conclusion.

Standard Test Method for Saybolt Furol Viscosity of

The efflux time was measured for each configuration of length and diameter of exit pipes The results obtained from the develop setup were analyzed and compared to relevant results available from.

Softening Point Lab Report 1453 Words Internet Public

PDF fileCalculation and Report 111 Multiply the efflux time by the correction factor for the viscometer determined in 91 112 Report the corrected efflux time as the Saybolt Furol viscosity of the material at the temperature at which the test was made 1121 Report values below 200 s to the nearest 05 s Report.